Chapter 2
Switch Installation
The plug-socket combination must be accessible at all times, because it serves as the main
Warning
disconnecting device. Statement 1019
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection.
10/100/1000 Ethernet Statement 1044
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
To comply with the Telcordia GR-1089 Network Equipment Building Systems (NEBS) standard for
Caution
electromagnetic compatibility and safety, connect the Ethernet cables only to intrabuilding or
nonexposed wiring or cabling.
Note
The grounding architecture of this product is DC-isolated (DC-I).
You can use the grounding lug to attach a wrist strap for ESD protection during servicing.
OL-16447-01
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
Warnings
2-3