Wall-Mounting; Attaching Brackets For Wall-Mounting - Cisco ME 3400E Hardware Installation Manual
Cisco systems ethernet access switch installation guide
Hide thumbs
Also See for Cisco ME 3400E:
- Hardware installation manual (26 pages) ,
- Getting started manual (16 pages) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
Installing the Switch
After the switch is mounted in the rack, you need to do these tasks to complete the installation:
•
•
•
•
For configuration instructions about using the CLI setup program, go to
Switch with the CLI-Based Setup Program."
Wall-Mounting
•
•
Wall-mounting has not been evaluated for NEBS applications.
Note
Attaching Brackets for Wall-Mounting
Figure 2-11
1
Follow the same steps to attach the second bracket to the opposite side.
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
2-14
Power on the switch. See the
Connect to the RJ-45 connector of a dual-purpose port, and run the initial configuration dialog.
See the Cisco ME 3400E Ethernet Access Switch Getting Started Guide for instructions.
Connect to the front-panel ports. See the
on page
2-22, the
"Connecting to Fiber-Optic SFP Modules" section on page
"Connecting to 1000BASE-T SFP Modules" section on page 2-25
We recommend attaching the cable guide to prevent the cables from obscuring the front panel of the
switch and the other devices installed in the rack. Use the supplied black screw shown in
to attach the cable guide to the left or right bracket.
Attaching Brackets for Wall-Mounting, page 2-14
Mounting the Switch on a Wall, page 2-15
Attaching 19-inch Bracket to Wall-Mount Cisco ME 3400EG-12CS-M or
Cisco ME 3400E-24TS-M
Phillips truss-head screws
"Verifying Switch Operation" section on page
"Connecting to the 10/100 and 10/100/1000 Ports" section
1
Chapter 2
Switch Installation
2-5.
2-24, and the
to complete the installation.
Figure 2-9
Appendix C, "Configuring the
OL-16447-01
Advertisement
Table of Contents
