Cisco Nexus 93180YC-FX3 Hardware Installation Manual page 27

Aci-mode switch

Hide thumbs Also See for Nexus 93180YC-FX3:

Table of Contents

Installing the Switch Chassis

b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the

rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front

rack-mount brackets come in contact with two rack or cabinet posts.

c) Holding the chassis level, insert screws (12-24 or 10-32, depending on the rack type) in each of the two front rack-mount

brackets (using a total of six screws) and into the cage nuts or threaded holes in the vertical rack-mounting rails (see

the following figure).

d) Tighten the 10-32 screws to 20 in-lb (2.26 N·m) or tighten the 12-24 screws to 30 in-lb (3.39 N·m).

Step 5

If you attached a grounding wire to the chassis grounding pad, connect the other end of the wire to the facility ground.

Installing the Switch Using the NXK-ACC-KIT-1RU Rack-Mount Kit

Cisco Nexus 93180YC-FX3 ACI-Mode Switch Hardware Installation Guide

Table of Contents

Show Quick Links

Table of Contents

N9k-c93180yc-fx3 N9k-c93180yc-fx3h