Multibase for Cisco Headset 560 Series
Number
2
3
4
You use the source control buttons on the base to control the active source. Each source button corresponds
with a specific connection on the multibase.
Even if you are connected to a source, the LED may not be lit. The source LED only lights when the source
is selected or has an active call. For example, you may be properly connected to aCisco IP phone, your PC,
and your mobile phone through Bluetooth. However, the respective source LED is only lit when it is selected,
has an active call, or has an incoming call. Press the source button to check if a source is properly connected.
The source LED flashes three times if there is no connection.
You can alternate between active call sources.
Note
Place an active call on hold before you change to a different call source. Calls on one call source aren't
automatically put on hold when you switch to a different call source.
Cisco IP Phone 7800 Series User Guide
76
Name
Call status LEDs
Mute status LED
Bluetooth status LED
Description
Alerts you to the call state of each source:
• Active Source—Steady white
• Incoming call on a selected source—Blinks green
• Incoming call on an unselected source—Blinks green
• Active call—Steady green
• Call on an inactive source—Pulses green
Alerts you when your headset is muted.
Alerts you to the Bluetooth status:
• Paired with a call source—Steady white
• Pairing mode—Blinking white
• Searching for a call source—Pulse white
• Bluetooth is Off—LED is off
Accessories