Table of Contents
Advertisement
No.
Display in the Result
5
Not Specified
6
Setting Reserved
7
Alert (Time-out of Setting Completion)
8
Alert (NAS OS Internal Error)
9
Alert (Time-out of Setting)
10
Alert (Segment Duplication)
192
Chapter 7 Configuring Storage on the Thunder 9530™ V Series Subsystem
Failure and Measure
The setting has not completed yet because the NAS unit
is activating.
Wait until the NAS unit becomes normal, press the
Refresh button again to refresh the display.
If the same information is displayed no matter how many
times the update is repeated, contact the maintenance
personnel.
The setting has not been completed because the NAS
unit stops. The setting will be made when the NAS unit is
restarted.
Wait until the NAS unit restarts, and press the Refresh
button again to refresh the display.
If the same information is displayed no matter how many
times the update is repeated, contact the maintenance
personnel.
There was no response regarding the setting from the
NAS unit although a certain period of time passed.
When a failure occurs in the subsystem or in the NAS
unit, contact the maintenance personnel.
When no failure occurs in the subsystem or in the NAS
unit, make the setting again.
If the same information is displayed in spite of the above
operation, contact the maintenance personnel.
The setting could not be changed because a failure
occurred inside the NAS OS.
When a failure occurs in the NAS unit, contact the
maintenance personnel.
When no failure occurs in the NAS unit, make the setting
again.
If the same information is displayed in spite of the above
operation, contact the maintenance personnel.
The setting could not be changed because a time out
occurred inside the NAS OS during the setting.
When a failure occurs in the NAS unit, contact the
maintenance personnel.
When no failure occurs in the NAS unit, make the setting
again.
If the same information is displayed in spite of the above
operation, contact the maintenance personnel.
The network address intended to be set has already
been used for a port of the NAS unit. Set other IP
address of the maintenance port.
When the same information id displayed no matter which
IP address is specified, set the maintenance port ID
address, which has been set before the change, again,
and change the duplicate IP address of the port.
Advertisement
Table of Contents
Troubleshooting
