Table of Contents
Advertisement
8.4.5.2
Flash Detected Messages
When the following Flash detected messages are displayed, follow the instructions to resolve
the problem.
Table 8.5
Flash Detected Messages
Message Code
RA00xx
RA7000
RB0000
RB0600
RB0A00
RB0E00
RB3000
RB3100
RB3200
RB3500
RB3600
RB7000
RB8000
RB8300
RBA000
When a Flash detected message other than those shown above is displayed, inform your
Customer Engineer of the message code.
246
Chapter 8 Troubleshooting
Message Text
Microprogram error [FLS]
Microprogram revision mismatch
Upload system error
No micro program
Upload file SUM check error
Up grade check NG
File size error
File open error
File read error
Bad block ID
Bad LBA in START 600 DAT
Program size too large
Old microprogram exists
Empty system retry full install
Down grade check NG
Recovery Measures
Restarting the equipment.
Check the microprogram you want to install and install it over
again.
Perform the new installation upgrade.
A sum check error occurred in a read file during an upload.
Check the microprogram you want to install and install it over
again.
The upgrade check of the microprogram failed. (An upgrade
version of a microprogram does not conform to the
microprogram being upgraded.) Do a new install of the
microprogram.
Check the microprogram you wish to install.
If the installation can be continued, the RAID group and LU
deformation are initialized. (In this case, all the data in the disk
drive are deleted. When the data in the disk drive need to be
saved, stop the work and perform the update installation.
The update installation cannot be executed because a system
does not exist in the disk drive.
Execute a new installation.
The present microprogram version cannot be updated to a
specified microprogram version.
Check the work procedure.
Execute a new installation.
Advertisement
Table of Contents
Troubleshooting
