Configuring The Ip Slas Responder - Cisco ME 3400 Software Configuration Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Command reference manual (950 pages) ,
- Hardware installation manual (88 pages) ,
- Getting started manual (33 pages)
Table of Contents
Advertisement
Chapter 39
Configuring Cisco IOS IP SLAs Operations
Before configuring any IP SLAs application, you can use the show ip sla application privileged EXEC
command to verify that the operation type is supported on your software image. This is an example of
the output from the command:
Switch# show ip sla application
Version: 2.2.0 Round Trip Time MIB, Infrastructure Engine-II
Time of last change in whole IP SLAs: 22:17:39.117 UTC Fri Jun
Estimated system max number of entries: 15801
Estimated number of configurable operations: 15801
Number of Entries configured
Number of active Entries
Number of pending Entries
Number of inactive Entries
Type of Operation to Perform: 802.1agEcho
Type of Operation to Perform: 802.1agJitter
Type of Operation to Perform: dhcp
Type of Operation to Perform: dns
Type of Operation to Perform: echo
Type of Operation to Perform: ftp
Type of Operation to Perform: http
Type of Operation to Perform: jitter
Type of Operation to Perform: pathEcho
Type of Operation to Perform: pathJitter
Type of Operation to Perform: tcpConnect
Type of Operation to Perform: udpEcho
IP SLAs low memory water mark: 21741224
Configuring the IP SLAs Responder
The IP SLAs responder is available only on Cisco IOS software-based devices, including some Layer 2
switches that do not support full IP SLAs functionality, such as the Catalyst 2960 or the Cisco ME 2400
switch or a Cisco ME 3400 switch running the metro base image. Beginning in privileged EXEC mode,
follow these steps to configure the IP SLAs responder on the target device (the operational target):
Command
Step 1
configure terminal
Step 2
ip sla responder {tcp-connect |
udp-echo} ipaddress ip-address port
port-number
Step 3
end
OL-9639-07
IP SLAs
: 0
: 0
: 0
: 0
Supported Operation Types
Purpose
Enter global configuration mode.
Configure the switch as an IP SLAs responder.
The keywords have these meanings:
tcp-connect—Enable the responder for TCP connect operations.
•
udp-echo—Enable the responder for User Datagram Protocol (UDP)
•
echo or jitter operations.
ipaddress ip-address—Enter the destination IP address.
•
port port-number—Enter the destination port number.
•
Note
Return to privileged EXEC mode.
The IP address and port number must match those configured on
the source device for the IP SLAs operation.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring IP SLAs Operations
39-7
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
