Installing Wics And Vics; Safety Information - Cisco 1760 - VPN Bundle Router Hardware Installation Manual
Modular access router
Hide thumbs
Also See for 1760 - VPN Bundle Router:
- Quick start manual (40 pages) ,
- User manual (48 pages)
Table of Contents
Advertisement
Installing WICs and VICs
Installing WICs and VICs
Note
Safety Information
Warning
Warning
Warning
Cisco 1760 Modular Access Router Hardware Installation Guide
2-8
The router has four card slots that hold Cisco WICs and VICs. Either one or two
WICs may be installed, with the remaining slots holding VICs, as desired. If no
WICs are present in the slots, up to four VICs may be installed. Each WIC has one
or two WAN ports and each VIC has one or more voice ports. This section
describes the procedure for installing a WIC or a VIC in the router.
For details on specific WICs and VICs, on connecting a WIC to the WAN line or
VIC to the telephone and fax line, and on configuring the interface with Cisco IOS
software, refer to the Cisco WAN Interface Cards Hardware Installation Guide
that came with the cards.
This section lists safety warnings that you should be aware of before installing
WICs or VICs in the router. To see translated versions of these warnings, refer to
the Regulatory Compliance and Safety Information for the Cisco 1700 Routers
document that came with the router.
Before working on a system that has an on/off switch, turn off the power and
unplug the power cord.
Only trained and qualified personnel should be allowed to install or replace this
equipment.
Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals.
Chapter 2
Installation
78-13342-03
Advertisement
Table of Contents
Troubleshooting
