Optional Installation Steps; Connecting A Pc - Cisco 1760 - VPN Bundle Router Hardware Installation Manual
Modular access router
Hide thumbs
Also See for 1760 - VPN Bundle Router:
- Quick start manual (40 pages) ,
- User manual (48 pages)
Table of Contents
Advertisement
Chapter 2
Installation
Optional Installation Steps
Connecting a PC
Step 1
78-13342-03
SLOT 0 and SLOT 1 OK—On when a WIC or VIC is correctly installed in
•
the slot.
SLOT 2 and SLOT 3 OK—On when a VIC is correctly installed in the slot.
•
SLOT 0, SLOT 1, SLOT 2, and SLOT 3—Activity on ports 0 and 1 of each
•
of these slots varies, depending on the type of WIC or VIC installed. See
Table 1-5
in Chapter 1,
information on activity at different ports.
LINK—On when the router is correctly connected to the local Ethernet LAN
•
through the 10/100-Mbps Ethernet port.
This section describes the following installation steps that you might or might not
use, depending on your site and how you are configuring the router:
Connecting a PC
•
Connecting a Modem
•
If you want to configure the router through the Cisco IOS command-line interface
(CLI), you must connect the router console port to a terminal or PC. The cable
required for this connection is included with the router.
The PC must have some type of terminal emulation software installed. The
software should be configured with the following parameters: 9600 baud, 8 data
bits, no parity, 1 stop bit, and no flow control. Refer to the Cisco 1700 Router
Software Configuration Guide for detailed information about configuring the
router using Cisco IOS software.
Follow these steps to connect the router to a terminal or PC:
Connect the end of the light blue console cable with the RJ-45 connector to the
blue console port on the router, as shown in
Cisco 1760 Modular Access Router Hardware Installation Guide
"Cisco 1760 Router
Overview," for detailed
Figure
Optional Installation Steps
2-9.
2-13
Advertisement
Table of Contents
Troubleshooting
