Table of Contents
Advertisement
Chapter 24
Configuring SNMP
Understanding How SNMPv1 and SNMPv2c Work
The components of SNMPv1 and SNMPv2c network management fall into three categories:
•
•
•
SNMP network management uses these SNMP agent functions:
•
•
•
•
Note
The community string definitions on your NMS must match at least one of the three community string
definitions on the switch.
Catalyst enterprise LAN switches are managed devices that support SNMP network management with
the following features:
•
•
•
78-15486-01
Managed devices (such as a switch)
SNMP agents and MIBs, including Remote Monitoring (RMON) MIBs, which run on managed
devices
SNMP management applications, such as CiscoWorks2000, which communicate with agents to get
statistics and alerts from the managed devices
An SNMP management application, together with the computer it runs on, is called a
Note
network management system (NMS).
Accessing a MIB variable—This function is initiated by the SNMP agent in response to a request
from the NMS. The agent retrieves the value of the requested MIB variable and responds to the NMS
with that value.
Setting a MIB variable—This function is also initiated by the SNMP agent in response to an NMS
message. The SNMP agent changes the MIB variable value to the value that is requested by the
NMS.
SNMP trap—This function is used to notify an NMS that a significant event has occurred at an
agent. When a trap condition occurs, the SNMP agent sends an SNMP trap message to any NMS
that is specified as a trap receiver, under the following conditions:
–
When a port or module goes up or down
–
When temperature limitations are exceeded
–
When there are spanning tree topology changes
When there are authentication failures
–
When power supply errors occur
–
SNMP community strings—SNMP community strings authenticate access to MIB objects and
function as embedded passwords:
Read-only—Gives only read access to all objects in the MIB except the community strings
–
Read-write—Gives read and write access to all objects in the MIB; does not allow access to
–
community strings
Read-write-all—Gives read and write access to all objects in MIB, including community strings
–
SNMP traps (see the
"Configuring SNMPv1 and SNMPv2c from the CLI" section on page
RMON in the supervisor engine module software (see
RMON and RMON2 on an external SwitchProbe device
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
Understanding How SNMPv1 and SNMPv2c Work
Chapter 25, "Configuring
—
Release 8.1
24-6)
RMON")
24-5
- Quick Links:
- Configuration Guide
- Catalyst 2980G Switch
Hide quick links:
Advertisement
Table of Contents
