Configuring The Ssl Server Ip Address; Configuring The Ssl Server Port - Cisco 11503 - CSS Content Services Switch Configuration Manual
Content services switch ssl configuration guide
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Administration manual (392 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Configuring Back-End SSL Servers in an SSL Initiation Proxy List
Configuring the SSL Server IP Address
Note
Configuring the SSL Server Port
Note
Cisco Content Services Switch SSL Configuration Guide
6-8
To reset the port to the default value of 80, enter:
(config-ssl-proxy-list[ssl_list1])# no backend-server 1 port
The server IP address is the IP address for the real SSL server. To configure the
IP address for the real SSL server, use the backend-server number server-ip
command.
For example, to configure the server IP address 192.168.2.3, enter:
(config-ssl-proxy-list[ssl_list1])# backend-server 1 server-ip
192.168.2.3
To remove the real server IP address from the proxy list, enter:
(config-ssl-proxy-list[ssl_list1])# no backend-server 1 server-ip
If you have not configured the real server IP address when you issue the active
command, the following error message appears and the CSS does not activate the
list.
%% Error in backend-server 1: SSL-server/Backend-server must have valid
IP address
By default the port number for the real SSL server is port 443. To configure a
different server port for the SSL server, use the backend-server number
server-port command. Enter a port number from 1 to 65535.
If you configure the backend-server number ip address and server-ip commands
with the same address, configure the backend-server number port and
server-port commands with different port numbers.
For example, to configure the server port number 155, enter:
(config-ssl-proxy-list[ssl_list1])# backend-server 1 server-port 155
Chapter 6
Configuring SSL Initiation
OL-5655-01
Advertisement
Table of Contents
