Ssl Initiation Service Quick Start; Table 2-8 Ssl Initiation Service Quick Start - Cisco 11503 - CSS Content Services Switch Configuration Manual
Content services switch ssl configuration guide
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Administration manual (392 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
SSL Initiation Service Quick Start
Cisco Content Services Switch SSL Configuration Guide
2-18
vip address 192.168.3.6
advanced-balance arrowpoint-cookie
protocol tcp
port 8080
url "/*"
add service ssl_serv2
active
content ssl_rule1
protocol tcp
vip address 192.168.3.6
port 444
application ssl
advanced-balance ssl
add service ssl-serv1
active
If you configured an SSL initiation server entry in an SSL proxy list,
provides an overview of the steps required to create an SSL service for an SSL
initiation server.
Table 2-8
SSL Initiation Service Quick Start
Task and Command Example
Create an SSL service.
1.
(config)# service ssl_serv1
Create service <ssl_serv1>, [y/n]: y
Specify ssl-init as the service type.
2.
(config-service[ssl_serv1])# type ssl-init
Configure the IP address for the service. The service IP address must be the
3.
same as the IP address specified in the SSL initiation proxy list using the
backend-server number ip address command. See the
List Quick Start"
section.
(config-service[ssl_serv1])# ip address 192.168.2.3
4.
Configure the service port. The service port must match the SSL initiation
back-end server port.
(config-service[ssl_serv1])# port 8080
Chapter 2
SSL Configuration Quick Starts
"SSL Initiation Proxy
Table 2-8
OL-5655-01
Advertisement
Table of Contents
