Tcp Keepalive-Timeout - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual
Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Configuration manual (700 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 23
T Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
tcp keepalive-timeout
To configure the interval between which the TCP connection verifies if the FCIP link is functioning, use
the tcp keepalive-timeout command. Use the no form of this command to disable this feature or revert
to its factory defaults.
Syntax Description
seconds
Defaults
60 seconds.
Command Modes
FCIP profile configuration submode.
Command History
Release
1.1(1)
Usage Guidelines
This command can be used to detect FCIP link failures.
Examples
The following example configures a FCIP profile:
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)#
The following example specifies the keepalive timeout interval for the TCP connection:
switch(config-profile)# tcp keepalive-timeout 120
Related Commands
Command
fcip profile
show fcip profile
OL-18089-01, Cisco MDS NX-OS Release 4.x
tcp keepalive-timeout seconds
no tcp keepalive-timeout seconds
Modification
This command was introduced.
Description
Configures FCIP profile parameters.
Displays FCIP profile information.
Specifies the time in seconds. The range is 1 to 7200.
Cisco MDS 9000 Family Command Reference
tcp keepalive-timeout
23-27
Advertisement
Table of Contents
