Installing Storage Media In A Supervisor Module - Cisco Nexus 7000 Hardware Installation And Reference Manual
7000 series
Hide thumbs
Also See for Nexus 7000:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
Chapter 4
Installing a Cisco Nexus 7010 Chassis
Installing Storage Media in a Supervisor Module
Figure 4-9
ESD Grounding Port on the Rear of the Cisco Nexus 7010 Chassis
1
ESD grounding port
Installing Storage Media in a Supervisor Module
Each supervisor module on a Cisco Nexus 7000 Series switch is shipped with a CompactFlash card
installed in the LOG FLASH reader (Supervisor 1 modules) or a USB drive installed in the LOG FLASH
reader (Supervisor 2 and Supervisor 2E modules). The EXPANSION FLASH reader (Supervisor 1) or
Slot0 port (Supervisor 2 and 2E) is left empty, but you can optionally install a card in that reader or a
USB drive in the USB port. To allow this storage media to function with the reader or port, you must
make sure that it is either formatted for the reader before installing it or format it after installing it.
The LOG FLASH and EXPANSION FLASH or Slot0 readers require different formats for their storage
Note
media.
To replace an installed CompactFlash card, see the
"Replacing Storage Media for a Supervisor Module"
section on page
10-59.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
4-16
OL-23069-07
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
