Administrator Password - IBM xSeries 330 Hardware Maintenance Manual
Type 8675
Hide thumbs
Also See for xSeries 330:
- Hardware maintenance manual (158 pages) ,
- Hardware maintenance manual (194 pages)
Table of Contents
Advertisement
Setting the password override switch: The following illustration shows the
location of the password override switch, switch 8 of switch block 1, on the system
board.
Note: The illustrations in this document might differ slightly from your hardware.
To set the password override switch:
1. Review the information in "Before you begin" on page 48.
2. Turn off the server and peripheral devices and disconnect all external cables
3. Toggle switch 8 on switch block 1 on the system board. This clears the
4. Replace the cover.
5. Connect the server to a power source, keyboard, monitor, and mouse.
6. Power on the server.
Note: You can now start the Configuration/Setup Utility program and either
Administrator password
Select this choice to set an administrator password. The administrator password
provides access to all choices on the Configuration/Setup Utility main menu. You
can set, change, or delete both the administrator and power-on passwords, and
allow a power-on password to be changed by the user.
36
Hardware Maintenance Manual: xSeries 330 Type 8675
and power cords; then, remove the cover. See "Removing the cover" on
page 51.
power-on password for one startup cycle.
Note: This means that you can now start or power-up the server one time
without having to use the power-on password. But if you do not use the
Configuration/Setup Utility program to change or delete the password,
the next time you start the server the original power-on password will
be reinstated.
delete the old password or set a new power-on password.
Switch block
(SW1)
Advertisement
Table of Contents
