Connecting The Flexstack Cables - Cisco Catalyst 2960-S Started Manual
Switch getting
Hide thumbs
Also See for Catalyst 2960-S:
- Hardware installation manual (94 pages) ,
- Software configuration manual (980 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Catalyst 2960-S Switch Getting Started Guide
Connecting the FlexStack Cables
Step 1
Step 2
Note
Step 3
OL-19793-02
Always use a Cisco-approved FlexStack cable to connect the switches. Connect
only Catalyst 2960-S switches in a switch stack.
Remove the dust covers from the FlexStack cables, and store them for future use.
Insert one end of the FlexStack cable into the stack port of the first switch. Insert
the other end of the cable into the stack port on the other switch.
When you connect the FlexStack cable into the STACK 1 port, the tab should be
above the connector. When you connect the FlexStack cable into the STACK 2
port, you should invert the cable so that the tab is below the connector.
Replace the dust covers when you remove the FlexStack cables from the
connectors.
Removing and installing the FlexStack cable can shorten its useful life. Do not
remove and insert the cable more often than is absolutely necessary.
Catalyst 2960-S Switch Getting Started Guide
23
Hide quick links:
Advertisement
Table of Contents
