Cisco Catalyst 2960-S Started Manual page 7
Switch getting
Hide thumbs
Also See for Catalyst 2960-S:
- Hardware installation manual (94 pages) ,
- Software configuration manual (980 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Catalyst 2960-S Switch Getting Started Guide
Step 5
Connect a Category 5 or 6 Ethernet cable to
one of these locations:
Any 10/100 or 10/100/1000 Ethernet
•
downlink port (such as port 1) on the
switch front panel.
•
The Ethernet management port on the
switch front panel.
Connect the other end of the cable to the
Ethernet port on your PC.
Before proceeding to the next step, wait until
the port LEDs on the switch and your PC or
laptop are green (either solid or blinking).
The green port LEDs indicate a successful
connection.
Troubleshooting:
If the port LEDs do not turn green after about
30 seconds, make sure that:
You connected the Ethernet cable to one
•
of the downlink switch ports (not to an
uplink port such as the dual-purpose
port).
You are using an undamaged Category 5
•
or 6 Ethernet cable.
The other device is turned on.
•
OL-19793-02
1X
11X
11X
13X
2X
23X
25X
12X
14X
36X
38X
24X
26X
37X
39X
Catalyst 2960-S Switch Getting Started Guide
Cata lyst
2960 XS
Series
PoE 10G
47X
48X
1
2
7
Hide quick links:
Advertisement
Table of Contents
