Configuring Dhcp Service - Cisco ASR 5000 Administration Manual
Enhanced wireless access gateway
Hide thumbs
Also See for ASR 5000:
- Administration manual (466 pages) ,
- Installation manual (294 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
DHCP-based Enhanced Wireless Access Gateway Configuration
radius accounting { client { <ipv4/ipv6_address> | <ipv4/ipv6_address/mask> } [
encrypted ] key <key> [ acct-onoff [ aaa-context <aaa_context_name> ] [ aaa-group
<aaa_server_group_name> ] [ clear-sessions ] + ] [ dictionary <dictionary_name> ] [
disconnect-message [ dest-port <destination_port_number> ] + | interim create-new-call }
#To enable mapping of UE MAC address to IMEIsV IE of GTP message in order to send it to
the GGSN:
map ue-mac-to-imei
#To configure timeout for D-eWAG session setup attempts:
setup-timeout <setup_timeout>
end
Notes:
<dictionary_name>
which dictionary to use in your setup, contact your Cisco account representative. For D-eWAG, the default
dictionary is
In the RADIUS accounting parameter configurations, the
RADIUS accounting messages to the configured RADIUS accounting client if the call goes down due to any
failure. If this option is not configured, the D-eWAG will not send Disconnect-Message in call failure
scenarios.
In the binding configuration, the
accounting requests are received. This keyword should be configured if the source of the RADIUS requests is
in a different context than the D-eWAG service. If not configured, the system will default to the context in
which the D-eWAG service is configured.
The
map ue-mac-to-imei
enabled, the UE MAC received in "Calling-Station-Id" RADIUS attribute is mapped to IMEIsV and sent in
GTP CPC message towards the GGSN.
A maximum of four W-APN can be configured per D-eWAG service. Also, note that a maximum of four default
gateways can be configured per W-APN.
Configuring DHCP Service
This section describes how to configure a DHCP service for the D-eWAG service.
To create and configure the DHCP service for D-eWAG use the following configuration:
configure
context <context_name>
dhcp-service <dhcp_service_name> [ -noconfirm ]
#To configure DHCP servers with which the DHCP service is to communicate:
dhcp server <ipv4_address> [ priority <priority> ]
specifies the RADIUS dictionary to use for the D-eWAG service. For information on
.
starent
source-context
CLI command supports enabling/disabling UE MAC to IMEI mapping. When
disconnect-message
option specifies the source context where RADIUS
Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide ▄
D-eWAG Configuration ▀
option enables sending
103
Advertisement
Table of Contents
