Configuring The Subscriber Template; Configuring The Sgtp Service - Cisco ASR 5000 Administration Manual
Enhanced wireless access gateway
Hide thumbs
Also See for ASR 5000:
- Administration manual (466 pages) ,
- Installation manual (294 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
▀ D-eWAG Configuration
#To bind the DHCP service to a logical IP interface facilitating the system's connection
to the DHCP server:
bind address <ipv4_address>
exit
Notes:
The DHCP service must be configured in the same context as the D-eWAG service, and must use the same IP
address as used for the D-eWAG service bind.
Configuring the Subscriber Template
This section describes how to configure subscriber profile for the D-eWAG service. The D-eWAG uses this
configuration to specify certain attributes in the subscriber profile.
To configure a subscriber template for D-eWAG use the following configuration:
configure
context <context_name>
subscriber { default | name <user_name> }
#To configure the accounting mode:
accounting-mode gtpp
#To configure the default APN to be used for UE connections when the AAA server does not
return the subscriber APN name in the service-selection AVP in RADIUS Access-Accept
message:
w-apn <wapn_name>
exit
#To configure realm part for subscriber. This command must be configured in the same
context where the AAA Group is defined.
domain <domain_name>
end
Configuring the SGTP Service
To create and configure the SGTP service use the following configuration:
configure
context <context_name>
sgtp-service <sgtp_service_name>
▄ Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide
104
DHCP-based Enhanced Wireless Access Gateway Configuration
Advertisement
Table of Contents
