Table of Contents
Advertisement
Spyder 3 GigE User's Manual
A4.7 Returning Camera Settings
Returning All Camera Settings with the Camera Parameter
Screen
The camera parameter (gcp) screen returns all of the camera's current settings. The table
below lists all of the gcp screen settings.
To read all current camera settings, use the command:
Syntax:
GCP Screen
GENERAL CAMERA SETTINGS
Camera Model No.:
Camera Serial No.:
Firmware Version:
CCI Version:
FPGA Version:
UART Baud Rate:
Dual Scan Mode:
Camera Mode:
Readout Mode:
Exposure Mode:
SYNC Frequency:
DALSA
gcp
SG-10-02K80
xxxxxxxxx
xx-xx-xxxxx-xx
xx-xxx-xxxxx-xx
xxx.xx
115200
High Sensitivity
2 taps, 12 bits
Off
7
5000.00 Hz
89
Description
Camera model number.
Camera serial number.
Firmware design
revision number.
CCI version number.
FPGA revision number.
Serial communication
connection speed set
with the
command.
s br
1 2 0 H
See
S etting Baud Rate
2 9 7 H
on page
5 4 for details.
2 9 8 H
Current sensitivity
mode set with the
s hm
1 2 1 H
command. See section
A 1.1 Sensitivity Mode
2 9 9 H
for details.
Current bit depth
setting set with the sdm
command. Refer to
section
A 1.3 Setting the
3 0 0 H
Bit Depth for details.
Current readout mode
status. Set using the srm
command.
Current exposure mode
value set with the
s em
1 2 2 H
command. See section
A 1.4 Exposure Mode,
3 0 1 H
Readout Mode, Line
Rate and Exposure
Time for details.
Current line rate. Value
is set with the
s sf
1 2 3 H
command. See section
A 1.4 Exposure Mode,
3 0 2 H
Readout Mode, Line
Rate and Exposure
Time for details.
03-032-10158-06
- Quick Links:
- Contents
- Gige Camera
- Features
- Models
- Installation Overview
- Power Connector
Hide quick links:
Advertisement
Chapters
Table of Contents
