Connecting The Dc Adapter - Cisco 800 Series Hardware Installation Manual
800 series integrated services router
Hide thumbs
Also See for 800 Series:
- Design manual (50 pages) ,
- Release notes (36 pages) ,
- Configuring (32 pages)
Table of Contents
Advertisement
Cisco 810 Series
To connect your Cisco 819 ISR to an AC power outlet, follow these steps:
Step 1
Connect the AC adapter to an AC power outlet.
Step 2
Plug the adapter cord into the router.
Connecting the DC Adapter
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than 36 VDC, 5A Statement 1005
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
Warning
installation. Install only in accordance with national and local wiring regulations. Statement 1045
The device is designed to work with TN power systems. Statement 19
Warning
To connect the DC power on your Cisco 819 ISR, follow these steps:
Connect the black and white lead wires to a 12 VDC source.
Step 1
The black lead is negative or ground and the white lead is positive. The output cable is 1.3 meters while
the input cable is 1 meter in length. (See
power adapters, see the
Figure 3-5
Cisco Integrated Services Router Hardware Installation Guide
3-6
"Supported Power Adapters" section on page
DC Power Supply PWR1-20W-12VDC and PWR1-20W-24VDC
2
1
Figure 3-5
and
Figure
3-6.). For the complete list of supported
Chapter 3
Connecting the Router
A-9.
3
- Quick Links:
- Hardware Features
Hide quick links:
Advertisement
Chapters
Table of Contents
