Accessing The Sim Card - Cisco 800 Series Hardware Installation Manual
800 series integrated services router
Hide thumbs
Also See for 800 Series:
- Design manual (50 pages) ,
- Release notes (36 pages) ,
- Configuring (32 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Router
Do not cover or obstruct the router vents located on both sides of the router; otherwise, overheating
Warning
could occur and cause damage to the router.
Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not
Warning
stack routers on a desktop. Excessive weight on top of the router could damage the chassis.
Do not install the router or power supplies next to a heat source of any kind, including heating vents.
Warning
Accessing the SIM Card
This section describes how to install and replace the SIM card. Ensure that the router is not mounted to
a wall, floor, or DIN rail.
Caution
Do not touch any part of the exposed PCB circuit area when the SIM cover is removed.
Hot surface. Statement 1079
Warning
To access the SIM card in the Cisco 819 ISR, follow these steps:
Step 1
Power off the router and disconnect the power cable from the power source.
Step 2
Place the router on its side and ensure that any installed antennas are carefully oriented.
Step 3
Remove the SIM access panel using four flat head #6 screws. (See
Step 4
Remove the SIM card and install the new cards.
Figure 2-18
Step 5
Replace the panel and the screws.
Accessing the SIM Cards
Cisco Integrated Services Router Hardware Installation Guide
Installing the Cisco 810 ISR
Figure
2-18.)
2-23
- Quick Links:
- Hardware Features
Hide quick links:
Advertisement
Chapters
Table of Contents
