Table of Contents
Advertisement
SCSI backplane
Complete the following steps to remove the SCSI backplane.
Note:
1. Turn off the server.
2. Disconnect all power cords and external cables from the back of the server.
3. Remove the server from the rack.
4. Pull out the hard drives.
5. Remove the server cover (see "Removing the cover and bezel" on page 46).
6. Disconnect th cables from the SCSI backplane.
7. Gently pull up on the backplane until it is released from the server at the
To replace the SCSI backplane, reverse the previous steps, making sure to align
the tabs and notches.
78
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
v Read "Installation guidelines" on page 39.
v Read the safety notices at "Safety information" on page 123.
v Read "Handling electrostatic discharge-sensitive devices" on page 126.
Note: The illustrations in this publication might differ slightly from your
hardware.
Retention
notches
notches; then, pull the backplane out of the server.
Retention tabs
Advertisement
Table of Contents
Troubleshooting
