Table of Contents
Advertisement
CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
switchxxxxxx#
show cdp tlv interface gi11
cdp globally is enabled
Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
Interface TLV: gi11
CDP is enabled
Ethernet gi11 is up,
Device ID TLV: type is MAC address; Value is 00:11:22:22:33:33:44:44
Address TLV: IPv4:
1.2.2.2 IPv6:
Port_ID TLV: gi11
Capabilities: S, I
Version TLV: 1 and 2
Platform TLV: VSD Ardd
Native VLAN TLV: 1
Full/Half Duplex TLV: full-duplex
Appliance VLAN_ID TLV: Appliance-ID is 1; VLAN-ID is 100
COS for Untrusted Ports TLV: 1
sysName: a-switch
Power Available TLV: Request-ID is 1 Power management-ID is 1;
4-wire Power-via-MDI (UPOE) TLV:
Request-ID is 1 Power management-ID is 1;
Available-Power is 15.4;
Management-Power-Level is 0xFFFFFFFF
4-pair PoE Supported: Yes
Spare pair Detection/Classification required: Yes
PD Spare Pair Desired State: Disabled
PSE Spare Pair Operational State: Disabled
Available-Power is 15.4;
8
232
Advertisement
Table of Contents
