Table of Contents
Advertisement
48
RADIUS Commands
48.4 radius-server host source-interface
Use the radius-server host source-interface Global Configuration mode command
to specify the source interface whose IPv4 address will be used as the Source
IPv4 address for communication with IPv4 RADIUS servers. Use the no form of this
command to restore the default configuration.
Syntax
interface-id
radius-server host source-interface
no radius-server host source-interface
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address belonging
to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 RADIUS server.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)#
vlan 100
radius-server host source-interface
969
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Advertisement
Table of Contents
