Table of Contents
Advertisement
Virtual Local Area Network (VLAN) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
•
vlan-list
remove
interface.
Default Configuration
The port is not a member in any Multicast TV VLAN.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
When an existed Multicast-TV VLAN is assigned to a customer port, the multicast
messages received on a membership of the Multicast-TV VLAN are forwarded to
the customer port. All messages received on the customer port are not bridged
only into the Multicast-TV VLAN.
To register IGMP reports arriving on the customer port by IGMP Snooping running
on the Multicast-TV VLAN, use the
A non-existed VLAN can be assigned as a Multicast-TV VLAN. If the Multicast-TV
VLAN does not exist the
"(Inactive)" after VLAN ID.
Example
The following example enables gi14 to receive Multicast transmissions from
VLANs 5, 6, 7.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
67.37 show vlan multicast-tv
Use the show vlan Multicast-tv EXEC mode command to display the source and
receiver ports of Multicast-TV VLAN. Source ports can transmit and receive traffic
to/from the VLAN, while receiver ports can only receive traffic from the VLAN.
Syntax
show vlan Multicast-tv vlan
Parameters
•
vlan-id
—Specifies the VLAN ID.
—Specifies a list of Multicast TV VLANs to remove from
ip igmp snooping map cpe vlan
show interfaces switchport
interface gi14
switchport customer multicast-tv vlan add
vlan-id
command.
command adds text
5-7
67
1292
Advertisement
Table of Contents
