Table of Contents
Advertisement
Power over Ethernet (PoE) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Field
Description
PSE standard
This indicated the PSE physical capability as
detected by the PD port (at power up time,
some devices may indicated 802.1AF at up
time but allow 802.1At/60WPOE power as
result of power negotiation).
If port is not connected to PSE or is in down
state the status is N/A.
Power available
This indicates the PSE allocated power (in
Watts).
If port is not connected to PSE or is in down
state the status is N/A.
If CDP/LLDP negotiation is activated than the
negotiation protocol is displayed "(CDP)" or
"(LLDP)".
If CDP/LLDP negotiation is activated than this
represent the maximum allocated power level.
In case the power negotiation is not completed
or has failed to negotiate power the value of
"Unknown" is displayed.
If no negotiation is activated this value is
derived from the PSE standard.
45
912
Advertisement
Table of Contents
