Debug Platform Etherchannel - Cisco catalyst 3750 Command Reference Manual
Hide thumbs
Also See for catalyst 3750:
- Software configuration manual (926 pages) ,
- Command reference manual (854 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
Appendix B
Catalyst 3750 Switch Debug Commands
debug platform etherchannel
Use the debug platform etherchannel privileged EXEC command to enable debugging of
platform-dependent EtherChannel events. Use the no form of this command to disable debugging.
Syntax Description
init
link-up
rpc
warnings
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.1(11)AX
Usage Guidelines
The undebug platform etherchannel command is the same as the no debug platform etherchannel
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Command
show debugging
OL-8552-07
debug platform etherchannel {init | link-up | rpc | warnings}
no debug platform etherchannel {init | link-up | rpc | warnings}
Display EtherChannel module initialization debug messages.
Display EtherChannel link-up and link-down related debug messages.
Display EtherChannel remote procedure call (RPC) debug messages.
Display EtherChannel warning debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
debug platform etherchannel
Catalyst 3750 Switch Command Reference
B-43
- Quick Links:
- Cli Command Modes
Hide quick links:
Advertisement
Chapters
Table of Contents
