Spanning-Tree Bpdufilter - Cisco catalyst 3750 Command Reference Manual

Hide thumbs Also See for catalyst 3750:

Table of Contents

spanning-tree bpdufilter

Use the spanning-tree bpdufilter interface configuration command to prevent an interface from

sending or receiving bridge protocol data units (BPDUs). Use the no form of this command to return to

the default setting.

Syntax Description

BPDU filtering is disabled.

Command Modes

Interface configuration

Command History

Usage Guidelines

You can enable the BPDU filtering feature when the switch is operating in the per-VLAN spanning-tree

plus (PVST+), rapid-PVST+, or the multiple spanning-tree (MST) mode.

Enabling BPDU filtering on an interface is the same as disabling spanning tree on it and can result in

spanning-tree loops.

You can globally enable BPDU filtering on all Port Fast-enabled interfaces by using the spanning-tree

portfast bpdufilter default global configuration command.

You can use the spanning-tree bpdufilter interface configuration command to override the setting of

the spanning-tree portfast bpdufilter default global configuration command.

This example shows how to enable the BPDU filtering feature on a port:

Switch(config)# interface gigabitethernet2/0/1

Switch(config-if)# spanning-tree bpdufilter enable

You can verify your setting by entering the show running-config privileged EXEC command.

Catalyst 3750 Switch Command Reference

spanning-tree bpdufilter {disable | enable}

no spanning-tree bpdufilter

Disable BPDU filtering on the specified interface.

Enable BPDU filtering on the specified interface.

Modification

This command was introduced.

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

Show Quick Links

Table of Contents