Appendix B
Catalyst 3750 Switch Debug Commands
debug eap
Use the debug eap privileged EXEC command to enable debugging of the Extensible Authentication
Protocol (EAP) activity. Use the no form of this command to disable debugging.
Syntax Description
all
authenticator
errors
events
md5
packets
peer
sm
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)SEE
Usage Guidelines
The undebug dot1x command is the same as the no debug dot1x command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Command
show debugging
show eap
OL-8552-07
debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
no debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
Display all EAP debug messages.
Display authenticator debug messages.
Display EAP error debug messages.
Display EAP event debug messages.
Display EAP-MD5 debug messages.
Display EAP packet debug messages.
Display EAP peer debug messages.
Display EAP state-machine related-events debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays EAP registration and session information for the switch or for the
specified port.
Catalyst 3750 Switch Command Reference
debug eap
B-11