Debug Platform Frontend-Controller - Cisco catalyst 3750 Command Reference Manual

Hide thumbs Also See for catalyst 3750:

Table of Contents

debug platform frontend-controller

Use the debug platform frontend-controller privileged EXEC command to enable debugging of

front-end controller activity. Use the no form of this command to disable debugging.

Syntax Description

Debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

This command is only supported on Power over Ethernet switches.

The undebug platform frontend-controller command is the same as the no debug platform

frontend-controller command.

When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack

member, start a session from the stack master by using the session switch-number privileged EXEC

command. Then enter the debug command at the command-line prompt of the stack member. You can

also use the remote command stack-member-number LINE privileged EXEC command on the stack

master switch to enable debugging on a member switch without first starting a session.

Catalyst 3750 Switch Command Reference

debug platform frontend-controller {all | image | led | manager | poe | register | thermal}

no debug platform frontend-controller {all | image | led | manager | poe | register | thermal}

Display all the debug messages for front-end controller.

Display Image Manager debug messages.

Display LED debug messages.

Display front-end-controller manager debug messages.

Display Power over Ethernet (PoE) debug messages.

Display Register Access debug messages.

Display thermal debug messages.

Modification

This command was introduced.

Catalyst 3750 Switch Debug Commands

Show Quick Links

Table of Contents