Monitoring And Maintaining The Interfaces; Monitoring Interface Status - Cisco Catalyst 2360 Software Configuration Manual
Ios 12.2(53)ey
Hide thumbs
Also See for Catalyst 2360:
- Hardware installation manual (74 pages) ,
- Getting started manual (21 pages)
Table of Contents
Advertisement
Monitoring and Maintaining the Interfaces
Command
Step 3
errdisable recovery interval interval
Step 4
errdisable recovery cause small-frame
Step 5
interface interface-id
Step 6
small violation-rate pps
Step 7
end
Step 8
show interfaces interface-id
Step 9
copy running-config startup-config
This example shows how to enable the small-frame arrival-rate feature, configure the port recovery time,
and configure the threshold for error disabling a port:
Switch# configure terminal
Switch# errdisable detect cause small-frame
Switch# errdisable recovery cause small-frame
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# small-frame violation rate 10000
Switch(config-if)# end
Monitoring and Maintaining the Interfaces
These sections contain interface monitoring and maintenance information:
•
•
•
Monitoring Interface Status
Commands entered at the privileged EXEC prompt display information about the interface, including
the versions of the software and the hardware, the configuration, and statistics about the interfaces.
Table 8-4
commands by using the show ? command at the privileged EXEC prompt.) These commands are fully
described in the Cisco IOS Interface Command Reference, Release 12.2.
Catalyst 2360 Switch Software Configuration Guide
8-24
Monitoring Interface Status, page 8-24
Clearing and Resetting Interfaces and Counters, page 8-25
Shutting Down and Restarting the Interface, page 8-26
lists some of these interface monitoring commands. (You can display the full list of show
Chapter 8
Purpose
(Optional) Specify the time to recover from the specified
error-disabled state.
(Optional) Configure the recovery time for error-disabled ports to
be automatically re-enabled after they are error disabled by the
arrival of small frames
Enter interface configuration mode, and specify the interface to be
configured.
Configure the threshold rate for the interface to drop incoming
packets and error disable the port. The range is 1 to 10,000 packets
per second (pps)
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Configuring Interface Characteristics
OL-19808-01
Advertisement
Chapters
Table of Contents
