Cisco Catalyst 2360 Software Configuration Manual page 410
Ios 12.2(53)ey
Hide thumbs
Also See for Catalyst 2360:
- Hardware installation manual (74 pages) ,
- Getting started manual (21 pages)
Table of Contents
Advertisement
Configuring QoS
Command
Step 4
end
Step 5
show mls qos interface
Step 6
copy running-config startup-config
To return a port to its untrusted state, use the no mls qos trust interface configuration command.
For information on how to change the default CoS value, see the
Interface" section on page
Configuring the CoS Value for an Interface
QoS assigns the CoS value specified with the mls qos cos interface configuration command to untagged
frames received on trusted and untrusted ports.
Beginning in privileged EXEC mode, follow these steps to define the default CoS value of a port or to
assign the default CoS to all incoming packets on the port:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
mls qos cos {default-cos | override}
Step 4
end
Step 5
show mls qos interface
Step 6
copy running-config startup-config
To return to the default setting, use the no mls qos cos {default-cos | override} interface configuration
command.
Catalyst 2360 Switch Software Configuration Guide
25-6
Purpose
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
25-6.
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
Valid interfaces include physical ports.
Configure the default CoS value for the port.
For default-cos, specify a default CoS value to be assigned to a port. If
•
the packet is untagged, the default CoS value becomes the packet CoS
value. The CoS range is 0 to 7. The default is 0.
Use the override keyword to override the previously configured trust
•
state of the incoming packet and to apply the default port CoS value to
the port on all incoming packets. By default, CoS override is disabled.
Use the override keyword when all incoming packets on specified ports
deserve higher or lower priority than packets entering from other ports.
Even if a port was previously set to trust CoS, this command overrides
the previously configured trust state, and all the incoming CoS values
are assigned the default CoS value configured with this command. If an
incoming packet is tagged, the CoS value of the packet is modified with
the default CoS of the port at the ingress port.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 25
Configuring QoS
"Configuring the CoS Value for an
OL-19808-01
Advertisement
Chapters
Table of Contents
