Creating A Configuration File By Using A Text Editor; Copying Configuration Files By Using Tftp; Preparing To Download Or Upload A Configuration File By Using Tftp; Downloading The Configuration File By Using Tftp - Cisco Catalyst 2360 Software Configuration Manual
Ios 12.2(53)ey
Hide thumbs
Also See for Catalyst 2360:
- Hardware installation manual (74 pages) ,
- Getting started manual (21 pages)
Table of Contents
Advertisement
Working with Configuration Files
Creating a Configuration File By Using a Text Editor
When creating a configuration file, you must list commands logically so that the system can respond
appropriately. This is one method of creating a configuration file:
Copy an existing configuration from a switch to a server.
Step 1
For more information, see the
page
"Downloading a Configuration File By Using RCP" section on page
Open the configuration file in a text editor, such as vi or emacs on UNIX or Notepad on a PC.
Step 2
Extract the portion of the configuration file with the desired commands, and save it in a new file.
Step 3
Copy the configuration file to the appropriate server location. For example, copy the file to the TFTP
Step 4
directory on the workstation (usually /tftpboot on a UNIX workstation).
Make sure the permissions on the file are set to world-read.
Step 5
Copying Configuration Files By Using TFTP
You can configure the switch by using configuration files you create, download from another switch, or
download from a TFTP server. You can copy (upload) configuration files to a TFTP server for storage.
These sections contain this configuration information:
•
•
•
Preparing to Download or Upload a Configuration File By Using TFTP
Before you begin downloading or uploading a configuration file by using TFTP, do these tasks:
•
•
Catalyst 2360 Switch Software Configuration Guide
B-10
Chapter B
B-11, the
"Downloading a Configuration File By Using FTP" section on page
Preparing to Download or Upload a Configuration File By Using TFTP, page B-10
Downloading the Configuration File By Using TFTP, page B-11
Uploading the Configuration File By Using TFTP, page B-11
Ensure that the workstation acting as the TFTP server is properly configured. On a Sun workstation,
make sure that the /etc/inetd.conf file contains this line:
tftp dgram udp wait root /usr/etc/in.tftpd in.tftpd -p -s /tftpboot
Make sure that the /etc/services file contains this line:
tftp 69/udp
You must restart the inetd daemon after modifying the /etc/inetd.conf and /etc/services files.
Note
To restart the daemon, either stop the inetd process and restart it, or enter a fastboot
command (on the SunOS 4.x) or a reboot command (on Solaris 2.x or SunOS 5.x). For more
information on the TFTP daemon, see the documentation for your workstation.
Ensure that the switch has a route to the TFTP server. The switch and the TFTP server must be in
the same subnetwork if you do not have a router to route traffic between subnets. Check connectivity
to the TFTP server by using the ping command.
Working with the Cisco IOS File System, Configuration Files, and Software Images
"Downloading the Configuration File By Using TFTP" section on
B-13, or the
B-17.
OL-19808-01
Advertisement
Chapters
Table of Contents
