Table of Contents
Advertisement
– Output Fail LED is Fault.
v Supervisor and switching modules:
– The System LED on the supervisor module is green, indicating that all
chassis environmental monitors are reporting that the system is
operational. If this LED is orange or red, one or more environmental
monitor is reporting a problem.
– The Status LED on the switching modules flashes orange once, remains
orange during diagnostic boot tests, and then turns green when the
module is operational (online). If the system software cannot start up, this
LED remains orange or turns red.
Note: Contact IBM Support for technical support.
4. Verify that the system software has booted and the switch has initialized
without error messages. If you cannot resolve an issue, contact your customer
service representative.
5. Complete the worksheets provided in Appendix C, "Site Planning and
Maintenance Records," on page 121, for future reference.
Note: A setup utility automatically launches the first time you access the
switch and guides you through the basic configuration. For instructions about
how to configure the switch and check module connectivity, see the Cisco
NX-OS Fundamentals Configuration Guide or the Cisco Fundamentals Configuration
Guide for DCNM SAN..
Chapter 3. Installing the IBM c-type SAN Device
89
- Quick Links:
- Ibm San192C-6
Hide quick links:
Advertisement
Table of Contents
