Siemens SINUMERIK 828D Commissioning Manual page 1060

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Programming commands

6.3 Functions

//M(TestGC/"Code generation:")

DEF VAR1 = (R//1)

DEF VAR2 = (R//2)

OUTPUT(CODE1)

"Cycle123(" VAR1 "," VAR2 ")"

D_NAME = "\MPF.DIR\MESSEN.MPF"

GC("CODE1",D_NAME)

Name of the OUTPUT method from which code is generated

Path name of target file for HMI or NC file system

If the target file is not specified (only possible within Program‐

ming Support), the code will be written to the location of the

cursor within the file that is currently open.

Option for generating comments.

0: (Default setting) Generate code with comment for the purpose

of recompilability (see also Recompile (Page 146)).

1: Do not create comments in the generated code.

Note: This code cannot be recompiled (see also Auto-Hot‐

This parameter is only relevant if a target file is specified.

0: (Default setting) If the file already exists, the old content is

1: If the file already exists, the new code is written at the start of

2: If the file already exists, the new code is written at the end of

; Write NC code from the OUTPUT method to file

\MPF.DIR\MESSEN.MPF:

Cycle123(123, -6)

SINUMERIK Integrate Run MyScreens

Programming Manual, 10/2015, 6FC5397-3DP40-5BA3

Show Quick Links

Chapters

Table of Contents