Dialog Selection Via Nc - Siemens SINUMERIK 828D Commissioning Manual

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Dialog selection via NC

MMC command in HMI Operate

You can use MMC commands as described in the following:

1. Definition of MMC commands

The following is available in the standard systemconfiguration.ini file.

Combinations:

address:=MCYCLES --> command:=LM

address:=CYCLES --> command:=PICTURE_ON

This distinction is necessary in order to differentiate between measuring cycles and other

cycles. This means that:

– LM is always applicable for measuring cycles, PICTURE_ON, always for non-measuring

– It is not permissible that newly defined MMC commands are designated PICTURE_ON

2. "Run MyScreens" license

All the dialogs opened by "Run MyScreen", with the exception of measuring cycles, fall

under the "Run MyScreens" license, which means that without license, only a limited

number of dialogs can be used.

Example call with test.com (Run MyScreens):

MMC("CYCLES,PICTURE_ON,test.com,screen form1","A")

MMC("CYCLES,PICTURE_OFF","N")

SINUMERIK Integrate Run MyScreens

Programming Manual, 10/2015, 6FC5397-3DP40-5BA3

Dialog selection

9.3 Dialog selection via NC

Show Quick Links

Table of Contents