Table of Contents
Advertisement
Chapter 10. Installing ProtecTIER Manager
Install the ProtecTIER Manager GUI on one or more designated ProtecTIER
Manager workstations. Do not install ProtecTIER Manager on the ProtecTIER
servers.
Use ProtecTIER Manager to:
v Configure ProtecTIER for use with the TS7650G
v Manage replication grids
v Create and manage virtual tape libraries
v Monitor the status of nodes and clusters
v Manage repositories and services
v Change the system configuration
The ProtecTIER Manager installer is provided on the IBM System Storage
ProtecTIER Manager V2.5 DVD. Because different ProtecTIER Manager installers are
provided for Windows and Linux, make sure that the installer you use is correct
for the operating system running on your ProtecTIER Manager workstation:
v If you are installing ProtecTIER Manager on a workstation running Windows,
v If you are installing ProtecTIER Manager on a workstation running Linux, see
Important: If an older version of ProtecTIER Manager is already installed on the
ProtecTIER Manager workstation or the TSSC, make sure the ProtecTIER Manager
GUI is closed before installing the newer version from the IBM System Storage
ProtecTIER Manager V2.5 DVD.
Installing on a Windows-based workstation
About this task
To install ProtecTIER Manager on Windows:
Procedure
1. Insert the IBM System Storage ProtecTIER Manager V2.5 DVD into the CD-ROM
© Copyright IBM Corp. 2008, 2010
see "Installing on a Windows-based workstation."
"Installing on Linux" on page 116.
drive of the designated ProtecTIER Manager workstation.
v If the ProtecTIER Manager Autorun launches and starts the installation, go to
step 2 on page 114.
v If the ProtecTIER Manager Autorun does not launch automatically, do the
following:
a. On the Windows task bar, click: Start → Run.
The Run dialog box opens.
b. In the Open field, type: D: (where D: is the server's CD-ROM drive)
c. Click OK.
The contents of the IBM System Storage ProtecTIER Manager V2.5 DVD,
display.
113
Advertisement
Table of Contents
