The Idler Assembly - Toro Greensmaster e1021 Service Manual
Hide thumbs
Also See for Greensmaster e1021:
- Diagnostic manual (84 pages) ,
- Operator's manual (44 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
The Idler Assembly
Removing the Idler Assembly
Universal Groomer (Optional): Service and Repairs
g282209
1.
Cotter pin
2.
Flange nut
3.
Flocked seal (2 each)
4.
Bushing
5.
Stub shaft
The groomer idler assembly is located on the opposite side of the groomer gear
box.
Note: Refer to
Figure 121
1. Remove the reel drive from the cutting unit; refer to
Assembly (page
4–7).
2. Remove the groomer reel assembly; refer to
(page
8–14).
3. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the idler arm. Discard the cotter pin.
4. Remove the flange nut that secures the idler arm to the stub shaft. Remove
the idler assembly.
5. Inspect the shields, bearing, and bushing in the idler assembly. Replace any
components that are worn or damaged.
Figure 121
6.
Shield
7.
Retaining ring
8.
Bearing
9.
Idler arm
10.
Clevis pin
during this procedure.
Page 8–12
Removing the Reel Drive
Removing the Groomer Reel
Greensmaster
®
e1021/e1026
20246SL Rev A
Advertisement
Chapters
Table of Contents
