BKM-150CP SDTI-CP/SDI Input Adaptor
Input of SDTI-CP/SDI signals
You can input SDTI-CP/SDI signals to connectors 1
and 3. Each input signals are output from connectors
2 and 4. You need not attach the 75-ohm
termination to connectors 2 and 4.
Assigning input signals to connectors
Before inputting signals to the BKM-150CP, you must
specify the type and format of the signal that will be
input to each connector.
For information about the signal assignment, refer to the
manual of your video monitor.
Note
After assigning input signals to each connector, carry
out the auto chroma/phase adjustment.
Specifications
General
Power requirements +5 V, ±6 V, +12 V
(supplied from the monitor)
Power consumption 13W
Operating conditions
Temperature
0°C to 35°C (32°F to 95°F)
Optimum temperature
20°C to 30°C (68°F to 86°F)
Humidity
0% to 90% (no condensation)
Pressure
700 hPa to 1060 hPa
Storage and transport conditions
Temperature
–10°C to 40°C (14°F to 104°F)
Humidity
0% to 90%
Pressure
700 hPa to 1060 hPa
Maximum external dimensions (w/h/d)
50 × 162 × 122 mm
(2 × 6
(2-slot size)
Mass
Approx. 580 g (1 lb 4 oz)
Input connectors
BNC × 2
SDTI/SDI
14
(E)
× 4
1
7
/
/
inches)
2
8
Output connectors
BNC × 2, active loop-through
SDTI/SDI
Phono jack × 2,
AUDIO
analog audio –5 dBu,
47 kilohm load
Signal characteristics
Video signals
Sampling frequency
Y
13.5 MHz
R-Y/B-Y
6.75 MHz
Quantization
SDTI-CP
8 bits
SDI
10 bits
Frequency response
Y
50 Hz to 5.75 MHz ±3 dB
R-Y/B-Y
100 Hz to 2.75 MHz ±2 dB
Chrominance/luminance signals
Delay time error 30 nsec max.
Gain error
5 % max.
K factor
1 % max. (2T pulse)
Audio signals
Channel number
SDTI-CP
8 ch
SDI
16 ch
Sampling frequency 48 kHz
Quantization
20 bits
Frequency response 20 Hz to 20 kHz ±1 dB
Others
Transmission distance
200 m (approx. 656 ft) max.,
When using 5C-2V coaxial
cables (Fujikura, Inc.) or
equivalent.
Return loss
15 dB min.
(5 MHz to 270 MHz)
Accessory supplied
Installation manual (1)
Design and specifications are subject to change
without notice.