Connecting A Video Terminal To The Pre Console Port - Cisco 10008 Hardware Installation Manual
Hardware installation guide
Hide thumbs
Also See for 10008:
- Quick start manual (49 pages) ,
- Software configuration manual (624 pages) ,
- Installation and configuration manual (70 pages)
Table of Contents
Advertisement
Connecting a Video Terminal to the PRE Console Port
Figure 3-30
Go to the
Step 8
installation.
Connecting a Video Terminal to the PRE Console Port
The Cisco 10008 router PRE module has an asynchronous serial (EIA/TIA-232) RJ-45 console port
labeled CON on its front panel. You can connect this port to most types of video terminals through use
of the console cable kit that is included with your Cisco 10008 router. The console cable kit contains:
•
•
•
A crossover cable reverses pin connections from one end to the other. In other words, it connects pin 1
(at one end) to pin 8 (at the other end), pin 2 to pin 7, pin 3 to pin 6, and so on. You can identify a
crossover cable by comparing the two modular ends of the cable. Hold the cable ends in your hand,
side-by-side, with the tabs at the back. Ensure that the wire connected to the outside (left) pin of the left
plug (pin 1) is the same color as the wire connected to the outside (right) pin of the right plug (pin 8).
Use the following procedure to connect a video terminal to the console port on a PRE module.
Each PRE must have a console port connection (typically to a terminal server) if you are running a
Note
redundant configuration in the chassis.
Cisco 10008 Router Hardware Installation Guide
3-30
Alarm Indicator Wires Exiting Safety Cover
"Connecting a Video Terminal to the PRE Console Port" section on page 3-30
One RJ-45 to RJ-45 crossover cable
One RJ-45 to DB-25 (female) adapter
One RJ-45 to DB-9 (female) adapter
Chapter 3
Installing the Cisco 10008 Router
to continue the
OL-0659-13
- Quick Links:
- Chapter 1 Cisco 10008 Router Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
