Replacing The Blower Module - Cisco 10008 Hardware Installation Manual
Hardware installation guide
Hide thumbs
Also See for 10008:
- Quick start manual (49 pages) ,
- Software configuration manual (624 pages) ,
- Installation and configuration manual (70 pages)
Table of Contents
Advertisement
Removing and Replacing Field-Replaceable Units
The directional arrows located on the metal frame of the filter should point up (see enlargement in
Note
Figure
Replacing the Blower Module
Use the following procedure to replace a blower module. The blower module supports hot-swapping (for
up to 2 minutes) and can be replaced without interruption to system operation.
To prevent the possibility of the system overheating, be sure that the replacement blower module is out
Caution
of its box and packaging, so it is ready to install as soon as the defective module is removed.
Figure 5-10
Remove the front cover if necessary (see
Step 1
Move any interface cables from the cable brackets on the blower so they are out of your work area, and
Step 2
then remove the cable brackets from the blower
Cisco 10008 Router Hardware Installation Guide
5-10
5-9).
Removing the Cable Brackets
FA NS
FA N
OK
FA ILU RE MU LT I-
FA N
FA ILU RE
1
2
3
CA UT IO
W he n ho
N
t sw ap pin
re m ov al
g th is fa
an d re pla
be do ne
n tra y,
ce m en
in un de
t m us t
sy ste m
r tw o m
sh ut do
inu te s
wn wi ll
or
oc cu r.
4
0 A
P R O C
E S S O R
0 B
O N LY
5
6
7
Front Cover Procedures, page
(Figure
5-10).
Chapter 5
Maintaining the Cisco 10008 Router
8
5-4).
OL-0659-13
- Quick Links:
- Chapter 1 Cisco 10008 Router Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
