Startup Display; Basic Configuration Using The Setup Facility - Cisco 10008 Hardware Installation Manual
Hardware installation guide
Hide thumbs
Also See for 10008:
- Quick start manual (49 pages) ,
- Software configuration manual (624 pages) ,
- Installation and configuration manual (70 pages)
Table of Contents
Advertisement
Chapter 4
Starting and Configuring the Router
Startup Display
When you power on your Cisco 10008 router or execute the reload command, the console screen
displays a message similar to the following:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Internetwork Operating System Software
IOS (tm) 10008 Software (C10K-P6-M), Experimental Version 12.0(20000413:055718)
[20000413:010004 104]
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Thu 13-Apr-00 04:20 by chrel
Image text-base: 0x60008900, data-base: 0x60A6E000
cisco C10008 (CRE-RP) processor with 114688K/16384K bytes of memory.
Processor board ID 00018655341
R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
Unknown midplane, Version 1.0
Last reset from register reset
Toaster processor tmc0 is running.
Toaster processor tmc1 is running.
1 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
509K bytes of non-volatile configuration memory.
40960K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
32768K bytes of Flash internal SIMM (Sector size 256KB).
Press RETURN to get started!
Basic Configuration Using the Setup Facility
The first time you power on a Cisco 10008 router, the setup facility starts. You can also initiate the
facility by running the setup command in privileged EXEC mode. This facility helps you enhance a
default configuration that already exists on the Cisco 10008 router. The setup facility uses a question
and answer sequence called the System Configuration Dialog to walk you through configuring the
router.
You do not have to configure the interfaces immediately; however, you cannot enable the interfaces or
connect them to any networks until you have configured them.
Tip
Basic configuration setup is often used as a quick way to achieve network connectivity, allowing you to
retrieve a configuration file from a TFTP server.
OL-0659-13
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Configuring the Cisco 10008 Router at Startup
Cisco 10008 Router Hardware Installation Guide
4-3
- Quick Links:
- Chapter 1 Cisco 10008 Router Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
