Cisco 10008 Hardware Installation Manual page 76
Hardware installation guide
Hide thumbs
Also See for 10008:
- Quick start manual (49 pages) ,
- Software configuration manual (624 pages) ,
- Installation and configuration manual (70 pages)
Table of Contents
Advertisement
Connecting Network Management and Signal System Cables
The wire connected to the left-most pin (pin 1) on one connector should be the same color as the
•
wire connected to the left-most pin on the other connector.
The same rule applies to pins 2 through 8 on each connector. The color of the wire attached to a pin
•
on one connector should match the color of the wire attached to the corresponding pin on the other
connector.
Caution
If the Cisco 10008 router is used in an environment in which lightning-induced transients are likely to
couple to the signal lines, use of shielded interconnection cables for the 100BASE-T ports is highly
recommended. In addition, use of shielded interconnection cables for the 100BASE-T ports is required
to meet Telcordia (formerly Bellcore) GR1089 CORE Section 4.5.9 and ETSI Section 5.2.2.2
(intrabuilding lightning surge).
The RJ-45 port on the PRE is configurable for 100-Mbps full-duplex or half-duplex operation
(half-duplex is the default) and supports IEEE 802.3, Ethernet, and IEEE 802.3u interfaces compliant
with 100BASE-T specifications.
Follow these steps to connect the PRE to a 100BASE-T Ethernet LAN:
Figure 3-34
Connect one end of the Ethernet cable to the RJ-45 port on the primary PRE, labeled ETH
Step 1
Step 2
Run the cable up and through the cable management bracket and connect the other end of the Ethernet
cable to any unoccupied port on the Ethernet hub.
Step 3
Check the LNK (Link) LED on the PRE (next to the ETH port).
This LED lights (green) if the PRE is correctly connected to the 10BASE-T Ethernet LAN.
Cisco 10008 Router Hardware Installation Guide
3-34
Connecting 100BASE-T to Ethernet Port
C IS C O
1 0 0 0 0
Chapter 3
Installing the Cisco 10008 Router
(Figure
3-34).
OL-0659-13
- Quick Links:
- Chapter 1 Cisco 10008 Router Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
