Troubleshooting The Console Port Serial Connection - Cisco 10008 Hardware Installation Manual
Hardware installation guide
Hide thumbs
Also See for 10008:
- Quick start manual (49 pages) ,
- Software configuration manual (624 pages) ,
- Installation and configuration manual (70 pages)
Table of Contents
Advertisement
Troubleshooting Installation Problems
•
For more information about configuring Ethernet ports, see the
Configuration
If the cable, connections, power, and configuration all check out, and you still cannot connect to the
Ethernet port on the module, you probably need to replace the PRE. Contact the Cisco TAC for further
assistance.
Troubleshooting the Console Port Serial Connection
If the terminal connected to the Cisco 10008 console port appears frozen or fails to work properly, check
for the following problems:
•
•
•
•
•
•
Cisco 10008 Router Hardware Installation Guide
4-14
If the LNK LED is on (green), but the Ethernet port does not seem to be working properly, make
sure that the port in question is configured properly and is not administratively shut down. If you
have a working console connection, perform the following steps:
At the router prompt, enter show int fast0/0/0. If the port is administratively down, enter these
–
commands to enable it:
switch> configure terminal
Enter configuration commands, one per line.
router(config-if)# int fast0/0/0
router(config-if)# no shut
router(config-if)# exit
router(config)# exit
router#
Check that the Ethernet port in question has a valid IP address assigned to it.
–
Guide.
Check the console cable and make sure it is properly connected to the correct console port on the
PRE, and to your equipment at the other end.
Verify that you are using the proper type of cable and adapter. For additional information about
cable pinouts, see the
"Connecting a Video Terminal to the PRE Console Port" section on page
To be sure the cable is not defective or broken, replace the cable with another high quality cable if
possible.
Check that your terminal equipment is working properly and configured with the correct settings for
the console port. The default console port settings are:
9600 baud
–
8 data bits
–
1 stop bit
–
No parity
–
No flow control
–
Check the LEDs on the PRE to make sure that it is powered on properly.
If the cable, connections, power, and terminal settings are all acceptable and you still cannot connect
to the console port on the module, you probably need to replace the PRE. Contact the Cisco TAC
for further assistance.
Chapter 4
Starting and Configuring the Router
End with CNTL/Z.
Cisco 10000 Series Router Line Card
3-30.
OL-0659-13
- Quick Links:
- Chapter 1 Cisco 10008 Router Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
