Table of Contents
Advertisement
Chapter 8
Configuring ATM Permanent Virtual Circuit Autoprovisioning
Example 8-10
the PVC.
Example 8-10 show atm pvc Command for a Specific PVC
Router# show atm pvc 0/51
ATM5/0.1: VCD: 118, VPI: 0, VCI: 51
UBR, PeakRate: 149760
AAL5-LLC/SNAP, etype:0x0, Flags: 0x20000C20, VCmode: 0x0
OAM frequency: 0 second(s), OAM retry frequency: 1 second(s), OAM retry frequency: 1
second(s)
OAM up retry count: 3, OAM down retry count: 5
OAM Loopback status: OAM Disabled
OAM VC state: Not Managed
ILMI VC state: Not Managed
InARP frequency: 15 minutes
Transmit priority 4
InPkts: 0, OutPkts: 0, InBytes: 0, OutBytes: 0
InPRoc: 0, OutPRoc: 0, Broadcasts: 0
InFast: 0, OutFast: 0, InAS: 0, OutAS: 0
InPktDrops: 0, OutPktDrops: 0
CrcErrors: 0, SarTimeOuts: 0, OverSizedSDUs: 0, LengthViolation: 0, CPIErrors: 0
Out CLP=1 Pkts: 0
OAM cells received: 0
F5 InEndloop: 0, F5 InSegloop: 0, F5 InAIS: 0, F5 InRDI: 0
F4 InEndloop: 0, F4 InSegloop: 0, F4 InAIS: 0, F4 InRDI: 0
OALM cells sent: 0
F5 OutEndloop: 0, F5 OutSegloop: 0, F5 OutRDI: 0
F4 OutEndloop: 0, F4 OutSegloop: 0, F4 OutRDI: 0
OAM cell drops: 0
Status: UP
PPP: Virtual-Access3 from Virtual-Template1
VC Auto Creation Enabled
Configuration Example for ATM PVC Autoprovisioning
The following example enables autoprovisioning on PVC range 100/100 to 100/3000 and applies the
virtual template interface named Virtual-Template1 to the PVC range.
ip local pool pool-1 10.1.1.2 10.1.12.255
!
interface Virtual-Template1
ip address 10.1.1.1 255.255.0.0
peer default ip address pool pool-1
ip mtu 1492
keepalive 60
ppp timeout idle 65
ppp direction callin
!
interface ATM7/0/0.1 point-to-multipoint
atm pppatm passive
range pvc 100/100 100/3000
create on-demand
idle-timeout 70
encapsulation aal5mux ppp Virtual-Template1
OL-2226-23
displays information about PVC 0/51 and indicates that autoprovisioning is enabled on
Cisco 10000 Series Router Software Configuration Guide
ATM PVC Autoprovisioning
8-13
Advertisement
Table of Contents
Troubleshooting
