hit counter script

Feature History For Ip Multicast; Restrictions For Ip Multicast; Configuration Tasks For Ip Multicast Routing; Enabling Dense Mode - Cisco 10000-2P2-2DC Software Configuration Manual

10000 series
Table of Contents

Advertisement

Feature History for IP Multicast

Feature History for IP Multicast
Cisco IOS Release
12.2(4)BZ1
12.3(7)XI1
12.2(28)SB

Restrictions for IP Multicast

The IP Multicast feature has the following restrictions:

Configuration Tasks for IP Multicast Routing

To configure basic IP multicast routing, perform the following tasks:
For information on other optional basic and advanced tasks, see the "IP Multicast" chapter in the
Cisco IOS IP Configuration Guide, Release 12.2.
Cisco 10000 Series Router Software Configuration Guide
15-34
Description
This feature was introduced on the Cisco 10000 series
router.
This feature was integrated into Cisco IOS Release 12.3(7)
XI1.
This feature was integrated into Cisco IOS Release
12.2(28)SB.
Cisco 10000 series router software does not support running Distance Vector Multicast Routing
Protocol (DVMRP) back to back between routers.
If you enable IP multicast fast switching on one interface, you must enable it on all outbound
interfaces on the router. Failure to do so results in the router sending duplicate multicast packets out
the interface that has fast switching enabled.
Cisco 10000 series router does not support accounting for Multicast packets on Packet over SONET
(POS) line cards, Gigabit Ethernet subinterfaces, and ATM AAL5 layer type.
The Cisco 10000 series router does not support fragmentation of multicast traffic.
The Cisco 10000 series router does not support fragmentation on Multicast Distribution Tree
(MDT). To avoid fragmentation, we recommend that the value of MDT Maximum Transmission
Unit (MTU) is set to a maximum of 64000.
Enabling IP Multicast Routing, page 15-35
Enabling PIM on an Interface, page 15-35
Enabling Dense Mode, page 15-35
Enabling Sparse Mode, page 15-36
Enabling Sparse-Dense Mode, page 15-36
Configuring Native Multicast Load Splitting, page 15-36
Configuring the Control Plane Protocol Policy, page 15-36
Chapter 15
Configuring IP Multicast
Required PRE
PRE1
PRE2
PRE2
OL-2226-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

1000510008

Table of Contents