Table of Contents
Advertisement
Assigning Basic Settings
Follow the steps in the
Step 5
to start over, follow the steps in the
Step 6
After configuring the bridge, remove the Ethernet cable from your PC and connect the power injector to
your wired LAN.
Note
When you connect your PC to the bridge or reconnect your PC to the wired LAN, you might need to
release and renew the IP address on the PC. On most PCs, you can perform a release and renew by
rebooting your PC or by entering ipconfig /release and ipconfig /renew commands in a command
prompt window. Consult your PC operating instructions for detailed instructions.
Assigning Basic Settings
After you determine or assign the bridge's IP address, you can browse to the bridge's Express Setup page
and perform an initial configuration:
Step 1
Open your Internet browser. The bridge web-browser interface is fully compatible with these browsers:
Microsoft Internet Explorer versions 5.0, 5.01, 5.5 and 6.0; and Netscape Navigator versions 4.79 and
7.0.
Enter the bridge's IP address in the browser address line and press Enter. An Enter Network Password
Step 2
screen appears.
Press Tab to bypass the Username field and advance to the Password field.
Step 3
Enter the case-sensitive password Cisco and press Enter. The Summary Status page appears.
Step 4
shows the Summary Status page.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
2-4
"Assigning Basic Settings" section on page
"Resetting the Bridge to Default Settings" section on page
Chapter 2
Configuring the Bridge for the First Time
2-4. If you make a mistake and need
2-2.
Figure 2-1
OL-4059-01
Advertisement
Table of Contents
