Table of Contents
Advertisement
Configuring System Message Logging
Table 18-2 Default System Message Logging Configuration (continued)
Feature
Timestamps
Synchronous logging
Logging server
Syslog server IP address
Server facility
Server severity
Disabling and Enabling Message Logging
Message logging is enabled by default. It must be enabled to send messages to any destination other than
the console. When enabled, log messages are sent to a logging process, which logs messages to
designated locations asynchronously to the processes that generated the messages.
Beginning in privileged EXEC mode, follow these steps to disable message logging:
Command
Step 1
configure terminal
Step 2
no logging on
Step 3
end
Step 4
show running-config
or
show logging
Step 5
copy running-config startup-config
Disabling the logging process can slow down the bridge because a process must wait until the messages
are written to the console before continuing. When the logging process is disabled, messages are
displayed on the console as soon as they are produced, often appearing in the middle of command output.
The logging synchronous global configuration command also affects the display of messages to the
console. When this command is enabled, messages appear only after you press Return. For more
information, see the
To re-enable message logging after it has been disabled, use the logging on global configuration
command.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
18-4
Default Setting
Disabled
Disabled
Disabled
None configured
Local7 (see
Informational (and numerically lower
levels; see
Purpose
Enter global configuration mode.
Disable message logging.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
"Enabling and Disabling Timestamps on Log Messages" section on page
Chapter 18
Configuring System Message Logging
Table 18-4 on page
18-11)
Table 18-3 on page
18-8)
18-6.
OL-4059-01
Advertisement
Table of Contents
