Table of Contents
Advertisement
Managing the System Time and Date
Command
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup-config
The specified interface is used for the source address for all packets sent to all destinations. If a source address
is to be used for a specific association, use the source keyword in the ntp peer or ntp server global
configuration command as described in the
Displaying the NTP Configuration
You can use two privileged EXEC commands to display NTP information:
•
•
For detailed information about the fields in these displays, refer to the Cisco IOS Configuration
Fundamentals Command Reference for Release 12.1.
Configuring Time and Date Manually
If no other source of time is available, you can manually configure the time and date after the system is
restarted. The time remains accurate until the next system restart. We recommend that you use manual
configuration only as a last resort. If you have an outside source to which the bridge can synchronize,
you do not need to manually set the system clock.
This section contains this configuration information:
•
•
•
•
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
5-26
Purpose
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
show ntp associations [detail]
show ntp status
Setting the System Clock, page 5-27
Displaying the Time and Date Configuration, page 5-27
Configuring the Time Zone, page 5-28
Configuring Summer Time (Daylight Saving Time), page 5-29
"Configuring NTP Associations" section on page
Chapter 5
Administering the Bridge
5-21.
OL-4059-01
Advertisement
Table of Contents
